FAQs

This product is effective when the furniture is leaned back against a wall, so if the flooring has cushioning this effect will lessen.
We recommend laying down a large board or plank and placing Falling Furniture Prevention Board and the furniture on that.

For increasing stability even more, we recommend you use it with a falling-prevention mechanism that props furniture against the ceiling. (We don’t sell falling-prevention support bars.)

This will considerably decrease its effectiveness, so please lay it down the whole of the front section of the furniture.

During an earthquake, because the weight will only be partially supported, the furniture’s balance will become unstable, decreasing the product’s effectiveness.

You can peel it off by sticking pieces of cellophane tape onto both the sheet and the film and pulling them away from each other.

The soapy water can be made by pouring water into a general-use sprayer, adding 2 to 3 drops of kitchen-use (neutral) detergent, and mixing well.
This soapy water fulfils a lubricating role for ventilation, wrinkle prevention, and preventing damage to the sheet, and using a lot of soapy water is the trick to sticking it on better.

It’s effective to stick it on the inside for window glass and on the outside for glass cupboards. This is so, if the glass should shatter, glass shards do not scatter within the room.

If there’s dirt on the sheet’s surface, please wipe it off using a soft cloth with neutral detergent. Please avoid using a dry cloth or polishing powder as it will damage the sheet. Also, please avoid using thinner or benzine.

You can, but if air bubbles or wrinkles occur, its appearance won’t look as good.

First please prepare a cutter that can cut well. It’s harder to peel off while the sheet is a large size, so make some vertical cuts, then cut it into rectangles of around 5 to 10cm in width (be careful not to cut the glass surface).
After that, cover it with wet newspaper and wait a while. Once the glue has become easier to peel off, start peeling the sheet off slowly starting from the corners.
It will be easier to peel off if you simultaneously spray soapy water with a sprayer between the sheet and the glass. If there’s glue remaining after you peel it off, please use a product for removing glue stains.

By shining ultraviolet light onto the Emergency-Use Glowing Tape (Fluorescent), it will radiate light in the dark. Without the ultraviolet light, it won’t be able to radiate light. Please use it where it can be exposed to fluorescent light or sunlight (indoors).